TAXI.com

Hi wonderful Taxi people where ever you are.

I am running Cubase Elements 9. Recently I had to get my computer checked out. When it came back, my UR22II wouldn't talk to my DAW. I reconfigured it in the Device setup menu, but now when I record an audio track, I am getting all the other tracks bleeding into the new recording. What the?? Can anyone tell me where I have gone wrong in the configuration, cause I can't seem to find the solution?

Thank you kind people.

Any ideas ??????

Is loop back enabled?
https://www.youtube.com/watch?v=7A6eHXVaBkw
Sounds like it might be in the interface.
I start with a new session when trouble shooting.
Good luck with it.

it's nothing to do with the interface. it's the sound settings and the sound control management. in other words, the ur22 is probably not the only sound interface you have, very likely the computer has an internal sound card also. basically you need to set up the ins and outs in the sound settings mixer.

right click on the speaker symbol, the default is usually at the bottom right near the time and date. Click on "open sound settings", choose your in, out, mic etc. you'll also see on that page a link to the sound control panel, that let's you choose
the devices used for playback and record as well. It's more of a bussing issue, if you have speakers out on the computer sound card and say spdif in from another device for recording, the speakers out will for example bus everthing. I hope I am making some sense.

Hi Les. Yes Loopback was enabled and now taken off. You're a legend.
Thanks for the info also Len. that's good knowledge to have as well.

Sweet, now I can tackle some listings.

thankyou guys.